Syllabus for Specialised Course on Topics in Additive Manufacturing

Fördjupningskurs inom additiv tillverkning

  • 5 credits
  • Course code: 1TM011
  • Education cycle: Second cycle
  • Main field(s) of study and in-depth level: Materials Engineering A1F

    Explanation of codes

    The code indicates the education cycle and in-depth level of the course in relation to other courses within the same main field of study according to the requirements for general degrees:

    First cycle

    • G1N: has only upper-secondary level entry requirements
    • G1F: has less than 60 credits in first-cycle course/s as entry requirements
    • G1E: contains specially designed degree project for Higher Education Diploma
    • G2F: has at least 60 credits in first-cycle course/s as entry requirements
    • G2E: has at least 60 credits in first-cycle course/s as entry requirements, contains degree project for Bachelor of Arts/Bachelor of Science
    • GXX: in-depth level of the course cannot be classified

    Second cycle

    • A1N: has only first-cycle course/s as entry requirements
    • A1F: has second-cycle course/s as entry requirements
    • A1E: contains degree project for Master of Arts/Master of Science (60 credits)
    • A2E: contains degree project for Master of Arts/Master of Science (120 credits)
    • AXX: in-depth level of the course cannot be classified

  • Grading system: Fail (U), Pass (G)
  • Established: 2021-10-18
  • Established by: The Faculty Board of Science and Technology
  • Revised: 2023-01-31
  • Revised by: The Faculty Board of Science and Technology
  • Applies from: Autumn 2023
  • Entry requirements:

    Bachelor's degree in Science and technology of at least 180 credits with 50 credits at an advanced level, including one of the courses Additive manufacturing in polymeric materials or Additive manufacturing in metallic and ceramic materials. Proficiency in English equivalent to the Swedish upper secondary course English 6.Proficiency in English equivalent to the Swedish upper secondary course English 6.

  • Responsible department: Department of Materials Science and Engineering

Learning outcomes

After passing the course, the student must be able to:

  • use previous knowledge to plan a study within a selected subject within additive manufacturing,
  • summarize and evaluate acquired knowledge within a the selected subject,
  • integrate, generalize and combine the aquired knowledge with previously knowledge in the field of additive manufacturing.

Content

The purpose of this course is to give students the opportunity learn aspects of additive manufacturing that is not covered by the regular courses in the master's program in additive manufacturing. The work is peformed individually and should be focused on literature studies.

The content is defined together with the program coordinator and program advisor to promote further studies within a particular specialisation of the Master programme in Additive Manufacturing .

Instruction

Self studies and supervision.

Assessment

Written report and oral presentation (5 credits). 

If there are special reasons for doing so, an examiner may make an exception from the method of assessment indicated and allow a student to be assessed by another method. An example of special reasons might be a certificate regarding special pedagogical support from the disability coordinator of the university.

Syllabus Revisions

Reading list

The reading list is missing. For further information, please contact the responsible department.

Print